Portable Service Centers 111 PORTABLE SERVICE CENTERS The Griffith • Vector Portable Service Center is a completely self con- tained drilling tool service shop designed for use in remote locations. The units are available in a single width using the Griffith • Vector Mini Torque, or in double or triple width using the Griffith • Vector Torquemaster.  All units are skid mounted structures, complete with integral floor sumps, overhead crane rails, ISO container mounts/lift points at the corners, insulated and sheeted walls and roof, full height doors, and hinged/removable side panels as necessary.  They require an external power source (specified by the customer) only, as all units are complete with a breaker panel and circuits for major equipment and accessories. TECHNICAL SPECIFICATIONS Per Container: Length: 35’ 6” With Skid • Width: 8’ • Height: 9’6” (8’ Inside Door Frames) • 3 Ton Overhead Craneway • 3 Ton Exterior Jib Crane Mount • Electrical: 3 Phase Power Customer to Specify Voltage & Frequency STANDARD EQUIPMENT: • Mini Torque (single) wide center • Torquemaster (double) wide center • Compressor • Sump pump – air lines and outlets • Work bench, cabinets, shelving • Lights and receptacles   • 3 Ton overhead crane ways • 3 Ton exterior jib crane mounts OPTIONAL EQUIPMENT • Jar tester • 3 ton overhead bridge cranes • 3 ton exterior jib cranes • Complete hand tool packages • Griffith service vice • Pulling post • Pressure washer • A/C unit or heater • Torquemaster accessories as required